The up and down switch currently automatically assign the midi commands to go to the next preset. But when you’re using a setlist on your tablet that will be confusing since each list will have a different order.
If I could assign my own midi commands then I can set my table up to go to the next/previous song with a midi command of my choosing.
When it comes to MIDI, the general consensus is that users want/need “the whole kitchen sink”–the ability to do anything and everything (with any footswitch). Check out these requests:
There are loads of midi commands that can be triggered on preset loading but only one per scene. A few more per scene would really help. Quite often you might want to change preset on an outboard pedal and turn one or two on or off so I think at least 4 commands would really help. If it could trigger midi notes as well that would be even better but I’d settle for 4 PC’s / CC’s
OK, this really needs to be fixed. The idea of having midi controls assigned ONLY to the switches is ridiculous and frustrating. It keeps this beautiful sounding device completely locked away from expansion. In reality it turns the “Most powerful floor modeler on the planet” into “Just another limited (yet expensive) 8-device/settings” processor. IF you can’t give us on/off (i.e. 0=off, 1 or higher = on) control for each device then assign on/off to the grid numbers and give us the ability to ma…
And because footswitch reassignment is a significant part of your request:
Let the user use an external tap tempo via midi or exp, and make it possible to use the tap tempo and bank down footswitches (all 10 footswitches or 11 including back up switch) to do whatever the user wants it to do. (Block bypass, scence, etc)
Similar to Command Center in Helix.
This could be sorted out with hybrid mode but being able to use at least the tap tempo switch to work as a simple block bypass would be nice, since it’s not possible to do by CC message yet.